Stroud Instruments Launch New Low Cost Hand-Held Current Loop And Voltage Calibrator
Designed with process instrumentation and control and automation systems integrators in mind, the calibrator provides current outputs in the range 0 - 20mA and voltage outputs in the range 0 - 10V.
In 20mA current sink mode the calibrator will simulate two-wire transmitters.
Key features:
• Source milliamps and volts
• Simulate two-wire transmitters (current sink mode)
• Three set-points provide fast selection between full-scale, zero and dial setting
• Dial setting stored when switched off
• Two speed dial setting
• 0.1% resolution
• Direct reading display mA / Volts
• Battery powered (universal mains power supply option)
The CAL-2 is supplied with a set of test leads, batteries and a synthetic rubber protective boot. The protective boot has a flip out stand – useful for test bench fault-finding work. An optional universal mains power adapter is also available.
CONTACT
Geoff Davis
Stroud Instruments Ltd
sales@sil.co.uk
www.sil.co.uk
+44 (0)1453 765433
Friday 11 November 2011 / file under Technology | Power | Environmental | Engineering | Energy | Electronics